Raymarine forum / Raymarine Forums / PC & Mobile v / [CA] [CA11] RNS 6.1 - Windows 7 Display Issue/Crashing - E120

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] RNS 6.1 - Windows 7 Display Issue/Crashing - E120
03-26-19, 12:41 PM
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: [CA11] RNS 6.1 - Windows 7 Display Issue/Crashing - E120
Welcome to the Raymarine Forum Sam,

Please note that it is generally recommended that RayTech RNS 6.1 be used with E-Series Classic MFDs. If operating with another version of RayTech software, then it is recommended that this version be installed. With regard to problems with Navionics cartography sharing, please indicate whether this problem began to appear following introduction of a new Navionics chart card to the system. Please additionally take a photo of the chart card(s) which are causing issues with the operation of the RayTech software. These photos should clearly permit all printing on the card's product label to be read.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] RNS 6.1 - Windows 7 Display Issue/Crashing - E120 - Chuck - Raymarine - Moderator - 03-26-19 12:41 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication