Raymarine forum / Raymarine Forums / Instruments v / [DG] [DG11] Speed no run with D800/P17 and itc-5

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[DG] [DG11] Speed no run with D800/P17 and itc-5
04-01-19, 02:23 PM
Post: #9
francisco Offline
Junior Member
**
 		Posts: 10
Joined: Feb 2017
Reputation: 0
RE: [DG11] Speed no run with D800/P17 and itc-5
Hello, I have a tridata, itc-5 and i70s.
I have good reading of wind, temp, and depth... but no speed (I only receive a 0.0 reading)
I checked the itc-5 and green light is constantly lit on.
I testes the ITC-5 with another speed sensor and it gave a correct reading (so ITC-5 is working fine)

Took the sensor out from the hull and speened the wheel with same reading 0.0

Sporadically, If I reset the unit (disconecting it or turning on/ off all instruments) I receive a wrong reading, speed jumps from 3knots to 20something knots, and all of a sudden turns to 0.0 again)... I have a sailboat.

I updated the software... and still have the same result.. only reading received is 0.0

Can you tell me how to proceed.
Best regards
Francisco
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [DG11] Speed no run with D800/P17 and itc-5 - francisco - 04-01-19 02:23 PM

Forum Jump:


User(s) browsing this thread: 4 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication