The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Instruments v / [CA] [CA11] Trouble Adding Tacktick T122 to Existing System

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Trouble Adding Tacktick T122 to Existing System
04-08-19, 11:22 AM (This post was last modified: 04-11-19 01:01 PM by Chuck - Raymarine - Moderator.)
Post: #1
bobcat Offline
Junior Member
**
 		Posts: 4
Joined: Apr 2019
Reputation: 0
[CA11] Trouble Adding Tacktick T122 to Existing System
I'm am unable to successfully add a Tacktick T122 to an existing Micronet network.

*The existing system has a T121, T111, T112, T113 & T120.
*The T122 was from another boat. Is powered from the same circuit as the T121 and has been charging for 96+ hours (did disconnect from power a few times as noted below).
*I have successfully added other units to this system recently (e.g. T113 remote from another boat)
*I tried adding it from from the T111, T112 & T113 both while connected to 12v source and battery only.
*Didn't have any NMEA connections in/out initially but did wire in one input on last try.
*Was closer than 12" to unit(s) I was attempting to add it form (had long wires on the 12v input)

Any suggestions?

Thanks
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] Trouble Adding Tacktick T122 to Existing System - bobcat - 04-08-19 11:22 AM

Forum Jump:


User(s) browsing this thread: 3 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication