The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Multifunction Displays v / [CA] [CA11] E-Series non hybrid button backlight not on

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] E-Series non hybrid button backlight not on
04-30-19, 11:19 AM (This post was last modified: 05-01-19 01:25 PM by Chuck - Raymarine - Moderator.)
Post: #1
Clyde Offline
Junior Member
**
 		Posts: 2
Joined: Apr 2019
Reputation: 0
[CA11] E-Series non hybrid button backlight not on
I have purchased a used sailboat with an E-Series MFD, auto pilot and wind instruments. (non-hybrid) I am new to using these three instruments and have noted that at night, I must use a flashlight to see the buttons built into them. I located a post dated 1-22-16 by Chuck (moderator) indicating that all instruments since 2000 have backlights but I have tried to determine exactly how to turn them on or off or adjust the brightness on the buttons but cannot figure it out. I think this is newer than 2000. I CAN adjust the brightness of the screen, but not the buttons. Can anybody offer instructions on how to do this, as I can't imagine they are malfunctioning--my guess is this is new operator oversight/error. Photo of box found on boat is included, but the photo does not show the main MFD. Another photo of it is included as well.

Thanks for any assistance.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] E-Series non hybrid button backlight not on - Clyde - 04-30-19 11:19 AM

Forum Jump:


User(s) browsing this thread: 2 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication