The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Instruments v / [CA] [CA11] T120 Wind Sensor with Axiom 9

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] T120 Wind Sensor with Axiom 9
05-01-19, 04:13 AM (This post was last modified: 05-01-19 10:29 AM by Chuck - Raymarine - Moderator.)
Post: #1
J220284 Offline
Junior Member
**
 		Posts: 1
Joined: May 2016
Reputation: 0
[CA11] T120 Wind Sensor with Axiom 9
Please advise if the latest software and connectivity in the Axiom 9 along with the rebranding of the T120 can now support a direct connection between the T120 and an Axiom 9 - including the calibration and any other required two-way communication?

Is a Microtalk Gateway required/still required?

If I purchase the T120 System with Display, does that eliminate the need for the Microtalk Gateway? (Yes, I have a SeaTalk(ng)(?) backbone connecting my Axiom 9 and Ray 70 VHF.)

Given that the Axiom 9 supports Bluetooth, should that not replace the need for the Microtalk Gateway?

In short, what is the most cost effective way to add a T120 to the top of my mast and see the data down below - given that I already own an Axiom 9 MFD? Just buy the system with the Display? Or, can I get by with just the T120 and my Axiom 9 and/or the addition of a Micronet gateway?

Thank you,
Jason Palmer.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] T120 Wind Sensor with Axiom 9 - J220284 - 05-01-19 04:13 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication