[LW11] DTS800 Not flush in fitting.

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[LW] [LW11] DTS800 Not flush in fitting.

05-01-19, 08:28 AM

Post: #5

Brian Bradley Offline

Junior Member

Posts: 3
Joined: Apr 2019
Reputation: 0

RE: [LW11] DTS800 Not flush in fitting.

Hi Louise

It appears that the strong arm of the engineer was required to put another three turns on the transducer fitted get it seated properly in the housing.
So itâ€™s now sorted.
The yellow o-ring and a good hard screw down weâ€™re needed.
Regards
Brian

« Next Oldest | Next Newest »

Messages In This Thread

[LW11] DTS800 Not flush in fitting. - Brian Bradley - 04-25-19, 02:08 AM

RE: [LW11] DTS800 Not flush in fitting. - Louise - Raymarine - Moderator - 04-26-19, 06:32 AM

RE: [LW11] DTS800 Not flush in fitting. - Brian Bradley - 04-26-19, 10:51 AM

RE: [LW11] DTS800 Not flush in fitting. - Louise - Raymarine - Moderator - 04-29-19, 10:15 AM

RE: [LW11] DTS800 Not flush in fitting. - Brian Bradley - 05-01-19 08:28 AM

RE: [LW11] DTS800 Not flush in fitting. - Louise - Raymarine - Moderator - 05-01-19, 09:48 AM

User(s) browsing this thread: 2 Guest(s)