[TG] [TG11] Linear Drive "Fluttering" when turning to Port

[bmackie]

Hello Tom:

We did have the rudder sensor installed. I disconnected it as you suggested and the problem appeared to go away.

I installed a "new" Rudder Sensor that I had as a spare and the problem now seems to rectified. I should note; prior to disconnecting the old unit today I also noticed that the rudder angles display seemed off. When the display had indicated full travel, in fact, the wheel continued to turn a significant amount - about 2 spokes (on our wheel) worth to Starboard and 1 spoke worth to Port.

I never did witness the "flickering or jumping" of the display rudder bar though.

With the new sensor the wheel stops almost immediately when the display bar reads full travel and is now traveling smoothly.

Thanks!

Bob Mackie
sv Hedonism
Outbound 46