[LW] [LW11] Adding one more autopilot (ACU200) and upgrading my network to STNG

[JonasE]

Thank for the input

I have read up on the manual a bit and taken your recommendations into consideration, still, have some questions though
- Power STng network through the ACU200
- Added terminals to the STng in the image (had already planned to use them, but had a hard time adding them to the last image)
- Extended to the STng network to the displays above the companionway and added an STng-ST1 converter
- Isolated the S2G and the ST6001 from the rest of the network

Not sure why should I not power the ST1 from the STng network or if this applies to both ST1 networks in my updated image?

- If I extend the STng network to the four displays and use an STng-ST1 converter I would not like to add power just for the three ST60 displays.
- At the Nav station, there will only be three devices on the ST1 network connected with the second STng-ST1 converter (MiniPlex, S100 and the old GPS RN300). Could the S100 and the MiniPlex not get power coming from the STng network?

Thanks for all the great support
/Jonas