[CA] [CA11] Axiom Pro no data on NMEA2000

[LimaBavo]

Hi there!

I have a new Axiom Pro setup on a NMEA2000 network. It is VERY basic: two T-connectors (one to Axiom, one to power) then 20' backbone to another T-connector for a YachtDevice YDES 04 engine gateway monitor.

Terminated on both ends.

The engine monitor does not see any data (usually will at least see the time and GPS position sentences to confirm data on the network), and the Axiom does not see the nmea2000 device....

I have two of everything so I replaced the gateway, drop cables and backbone, but same result.

Is there a setting that I can't find to activate nmea2000 on the Axiom?

I do have the two NMEA0183 inputs working fine on some legacy transducer and autopilot but the NMEA2000 seems inoperable....

Thanks!
LB