[CA11] EV-1 Calibration

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[CA] [CA11] EV-1 Calibration

05-13-19, 01:07 PM (This post was last modified: 05-14-19 08:55 AM by Chuck - Raymarine - Moderator.)

Post: #1

pinkish_panther Offline

Junior Member

Posts: 8
Joined: Jul 2017
Reputation: 0

[CA11] EV-1 Calibration

Is it possible to validate the EV-1 Compass calibration using an Axiom panel? I do not have the full autopilot solution, I just purchased the EV-1 to feed heading data, while stopped, to the chart.

I've tried forcing the automatic calibration but running figure 9's at 5-10 MPH and I've even seen pop up messages on the Axiom indicating the deviation was configured. Yet the results seem inconsistent.

The compass appears to correct it's deviation during long runs but then when powering up the system the next time it can be off by 20+ degrees.

Thoughts?

Thanks in advance.

« Next Oldest | Next Newest »

Messages In This Thread

[CA11] EV-1 Calibration - pinkish_panther - 05-13-19 01:07 PM

RE: [CA11] EV-1 Calibration - Chuck - Raymarine - Moderator - 05-14-19, 09:03 AM

RE: [CA11] EV-1 Calibration - pinkish_panther - 05-14-19, 05:45 PM

RE: [CA11] EV-1 Calibration - Chuck - Raymarine - Moderator - 05-15-19, 07:50 AM

RE: [CA11] EV-1 Calibration - pinkish_panther - 07-10-19, 10:21 AM

RE: [CA11] EV-1 Calibration - Chuck - Raymarine - Moderator - 07-16-19, 02:35 PM

User(s) browsing this thread: 1 Guest(s)