[DG] [DG11] e128

[Derek - Raymarine - Moderator]

Hi Luar,

Thank you for the feedback,
The LH3 software in the eS128 will not control the Autopilot, if you had an Evolution autopilot, then the LH3 software would control int, but because it is an older SPX30, the LH3 will not.

In order to use the autopilot to follow a route in the eS128 LH3, you will need to create a route in the eS128, select the route and then make it active - so you are tracking to the next target waypoint in the route, then using the autopilot control unit, select AUTO and then TRACK and it will follow the route from the eS128.

Regards
Derek