[TG11] Sounder Supply Voltage Too Low

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[TG] [TG11] Sounder Supply Voltage Too Low

05-15-19, 09:53 PM

Post: #10

Tom - Raymarine - Moderator Offline

Administrator

Posts: 1,067
Joined: Nov 2017
Reputation: 7

RE: [TG11] Sounder Supply Voltage Too Low

Hello Dave,

That's interesting that software resolved that problem. Not one I'd come across before, I'll watch out for it in future.

On the diagnostic page display - we are aware that the diagnostic page does not always display exactly what's in the network at all times, and I believe this is being looked at for improvement in future software. Although what you're seeing is not correct, I would not expect it to have any adverse impact on the rest of the system, however if you wanted to do so, I strongly suspect that a factory reset to all 3 displays would unify the product list. Make sure you back up all of your settings and data before you do a reset though.

Regards,
Tom

Raymarine since 1999.
Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras
Location: Sydney, Australia.

Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests.