Raymarine forum / Raymarine Forums / Multifunction Displays v / [TG] [TG11] Sounder Supply Voltage Too Low

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] [TG11] Sounder Supply Voltage Too Low
05-22-19, 10:35 AM
Post: #11
MarkPOrge Offline
Junior Member
**
 		Posts: 1
Joined: Aug 2016
Reputation: 0
RE: [TG11] Sounder Supply Voltage Too Low
I have the same problem with the A128 I just added last summer. The A128 at the helm functions fine, but I get the error after about 5 minutes of use. Voltage is good, I'll look for an update but according to the site V19.03 was out in April 2017, nothing new since?

The only difference is a new (separate) transducer for the front head. It is the A80351 and the one on the transom is the older version A80270. Not sure if that matters, I was going to try a new transducer or I could always network but I hope to avoid unnecessary costs and/or re-wiring.

Are we the only two reported cases of this?

Mark
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [TG11] Sounder Supply Voltage Too Low - MarkPOrge - 05-22-19 10:35 AM

Forum Jump:


User(s) browsing this thread: 2 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication