Raymarine forum / Raymarine Forums / Multifunction Displays v / [CA] [CA11] Update via mSD to 3.9 stuck

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Update via mSD to 3.9 stuck
05-29-19, 10:49 AM (This post was last modified: 05-29-19 01:25 PM by Chuck - Raymarine - Moderator.)
Post: #13
S Guttilla Offline
Junior Member
**
 		Posts: 7
Joined: Jun 2018
Reputation: 0
RE: [CA11] Update via mSD to 3.9 stuck
Re: the message below: I updated my Axiom 9 from 3.5 to 3.9 this week.I reported the problem that after upgrading, the Axiom could not find the Quantum Radar (WIFI connection). After starting the upgrade, I realized I had not powered on the Radar. I let the upgrade finish and then saw that the Axiom could not connect to the Quantum. I then proceeded to reinstall the upgrade with the Quantum powered on. Once again, the Axiom could not connect to the Quantum, so I went through the menu screens to find that the Quantum was no longer paired with the Axiom. I paired them once again and everything worked fine. The only thing I did not verify is if the Quantum was upgraded with any changes in the 3.9 files. Not sure how to proceed with that.

Sal
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] Update via mSD to 3.9 stuck - S Guttilla - 05-29-19 10:49 AM

Forum Jump:


User(s) browsing this thread: 5 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication