[CA] [CA11] Axiom Yamaha Engine Data

[Chuck - Raymarine - Moderator]

Welcome to the Raymarine Forum Hairraiser,

General comment: Please click here to view a FAQ addressing how the engines should be interfaced to your system.

Q1. My engines use the Yamaha conventional digital gauges and I do not have a CommandLink Hub. I have connected CommandLink to Devicenet cables to both engines. When I connect the engines to my NMEA backbone with the proper T's and Terminators, I can see the Port engine data on the Axioms but not Starboard. This configuration also drops my Fusion radio remotes.
A1. The method which you have described above is an invalid means to interface the engines to the marine electronics system. Please refer to the FAQ within the opening comment to view the proper means of interfacing your engines to the marine electronics system.

Q2. I would like to know if adding the ECI-100 would correct the issue and if I can create a separate NMEA network for the engines connecting to the ECI-100, then connect the ECI-100 to my backbone?
A2. As indicated within the referenced FAQ, an ECI-100 would be recommended for this application. For more information regarding the specifics of connecting the Yamaha engines via the ECI-100, please refer to the Yamaha tab of the ECI-100 Connectivity web page. While it is possible to utilize SeaTalkng networking components for the engine backbone, your diagram appears to be lacking in power for the engine backbone as would be accommodated by Yamaha's Command Link components.