Raymarine forum / Raymarine Forums / Instruments v / [CA] [CA11] Low voltage to itc5 for wind speed

Post Reply 
 
Thread Rating:
  • 1 Vote(s) - 4 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Low voltage to itc5 for wind speed
06-12-19, 02:06 PM (This post was last modified: 06-12-19 03:30 PM by Chuck - Raymarine - Moderator.)
Post: #7
Terry L. Brabb Offline
Junior Member
**
 		Posts: 9
Joined: Feb 2016
Reputation: 0
RE: [CA11] Low voltage to itc5 for wind speed
Chuck, really appreciate your help.
There is only one autopilot, the ACU 400.
The pc is loaded with Raytech 6.2. If I can get it to show radar might it also show other data, i.e. Wind depth, gps,? Or, could a separate gps antenna be connected to the pc?

Keeping the ssb and sat phone connected to the pc may allow email or text to be sent from the pc?
Termination plugs - one is at the itc5 and it appears I should add a 'T' with a termination plug at the autopilot ?
As for the Seatalk hs backbone cable I'm guessing it is the cable to the e125 mfd?
Not sure any of this is helping low voltage at itc5? And redid page 3.
Your thoughts please.


Attached File(s) Thumbnail(s)
   
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] Low voltage to itc5 for wind speed - Terry L. Brabb - 06-12-19 02:06 PM

Forum Jump:


User(s) browsing this thread: 2 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication