[CA] [CA11] Adding a P66 to Axiom 7

[Chuck - Raymarine - Moderator]

Welcome to the Raymarine Brizza,

It is quite common for Axiom RV owners to additionally install a compatible 50kHz/200kHz onboard and then interface it to the MFD via an Axiom RV Y-Cable. This is done not only for those seeking sonar in deeper depths than are supported by the RV transducer, but also for those seeking improved bottom tracking when operating at planing speeds. However, when this option is chosen, the low power, high frequency CHIRP conical sonar (referred to as the Sonar channel within the Fishfinder app) will not be available. In its place will be the 200kHz channel and 50kHz channel. If the E66054 P66 Transducer is installed, then the A80492 Axiom RV Y-Cable would be used.