Threaded Mode | Linear Mode

stevecti

I am trying to interface two Yacht Devices YDTA-01 tank adapters to my Seatalk NG network to use as fuel tank level sensors for my port and stb fuel tanks.

These have been configured as per Yacht Devices instruction with the port sender as device 0 and the Stbd as device 1. They are configured for fluid type 1 as Fuel/Diesel as Raymarine will not detect them when set for 6 which is gasoline.
They are set to standard USA specs, 240-33ohms .

I can see the tank adapters in my list of devices and the instance numbers are correct at 0 and 1. However the Axiom Pro is only displaying 1 tank which is Device 0 port. I cannot figure out a way to have it show 2 tanks. I have tried going through the calibration process by cheating and having ignition off for empty, on for full, which shouldn't be necessary, and can see the levels change. However I can only select information from the port device.

Is there something I am missing to have it show 2 tanks?
Is there a way for the Axiom to just display the data it is receiving from the device, instead of having to go through the calibration process? I don't have the ability to have a completely empty tank and then full.

Thank you