[CA] [CA11] Power cable for Quantum

[Piney Pete]

Chuck,

I have a cabling issue and thus a question for you. I have a new Q24C radome and it will be sitting on a stainless arch. The arch has a flat plate that the radome sits on and fastens to, and then the radar cable will come out the back of the radome (the Q24C has a channel) and make a drip loop then enter my arch tubing. But I'm running into a quandary.

My first choice was the Y connector and then the Digital Radar Cable, as you typically recommend, because then there is only one cable entering the [censored] in the arch (since this is 1-1/4" tubing, there can only be a grommet because it's too rounded for a gland). It's much easier to seal one cable (grommet fits cable well).

BUT, the Y connector is so long that the "aft" connector on the Y can't be under the radome in the channel, but instead hangs out the aft side of the radome. And being a connector it is stiffer and bulkier than cable. And then to compound it, the Digital Radar Cable will have its connector in series with the Y connector. That won't bend to make a nice drip loop and then enter my arch.

The other choice is a power cable *and* a Quantum Data Cable. Those won't have connectors dangling out the aft end of the radome, but then I'm stuck putting two cables through one round grommet and trying to seal the "crotch" between them (plus it's going to get tight with two vs. one inside the arch).

I did buy all three items (Y connector, DRC, QDC) so I could check them out. I had to open the Y connector to get an idea of how stiff it is. I was hoping I could loop the Y parts around (kind of like the first loop of a bowline) to take up some cabling and thus get the outgoing connector to land in the channel under the dome vs. sticking out aft but I don't think that's going to work.

Is there any way I can shorten the bottom (outgoing) leg of the "Y"? I'm comfortable soldering tiny wires, but don't want to dig in without checking in here first. I know, for example, that transducer wires can't easily be re-done but not sure about the "Y" connector here. I just need to make it shorter somehow so that the stiff connector part is not the part just aft of the dome where I need to make my drip loop and clean entry into the arch tubing.

Thank you,
PP