The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Autopilots v / [CA] [CA11] Autopilot loosing calibration settings

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Autopilot loosing calibration settings
06-19-19, 02:03 PM (This post was last modified: 06-20-19 03:52 PM by Chuck - Raymarine - Moderator.)
Post: #1
SetFree Offline
Junior Member
**
 		Posts: 1
Joined: Apr 2018
Reputation: 0
[CA11] Autopilot loosing calibration settings
Our new-to-us boat has a ST7001 control head interfaced to a S3G AST course computer. Each time I start up the instruments, I notice that the autopilot heading does not match the GPS heading - it's off by 15 degrees or so.

I have gone through the Seatrial Heading match calibration procedure which corrects the problem as long as I don't turn the system off. However, after the autopilot has been off, the heading is once again incorrect. I'm concerned if other calibration settings are being lost as well.

Can you let me know what can be done to preserve these settings? Thank you
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] Autopilot loosing calibration settings - SetFree - 06-19-19 02:03 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication