[CA11] Cannot identify the correct Data field for PGN 130576

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[CA] [CA11] Cannot identify the correct Data field for PGN 130576

06-25-19, 01:36 PM

Post: #3

pinkish_panther Offline

Junior Member

Posts: 8
Joined: Jul 2017
Reputation: 0

RE: [CA11] Cannot identify the correct Data field for PGN 130576

Thanks - I had modified the pre-defined page when I didn't have Trim data.
I did a factory reset and now have the data showing on that page.

Note that I'm experiencing the same issue I saw someone else post, my Merc Engine gateway is sending the same (bad) PGN number so the Raymarine is cycling the information every 1/2 second between 0 and the correct value. Another post here indicated the Raymarine will take the data with the lowest instance but my Lenco is set to instance 0 and the Engine GW is instance 2.

Perhaps another minor bug?

« Next Oldest | Next Newest »

Messages In This Thread

[CA11] Cannot identify the correct Data field for PGN 130576 - pinkish_panther - 06-17-19, 10:43 AM

RE: [CA11] Cannot identify the correct Data field for PGN 130576 - Chuck - Raymarine - Moderator - 06-19-19, 03:25 PM

RE: [CA11] Cannot identify the correct Data field for PGN 130576 - pinkish_panther - 06-25-19 01:36 PM

RE: [CA11] Cannot identify the correct Data field for PGN 130576 - Chuck - Raymarine - Moderator - 06-25-19, 01:51 PM

RE: [CA11] Cannot identify the correct Data field for PGN 130576 - pinkish_panther - 07-10-19, 10:16 AM

RE: [CA11] Cannot identify the correct Data field for PGN 130576 - Chuck - Raymarine - Moderator - 07-16-19, 07:38 AM

User(s) browsing this thread: 1 Guest(s)