[CA11] E120 Crash when set to 38400 BAUD

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[CA] [CA11] E120 Crash when set to 38400 BAUD - AIS is NMEA 0183

07-01-19, 09:07 AM

Post: #5

lotharjt Offline

Junior Member

Posts: 40
Joined: Feb 2016
Reputation: 1

RE: [CA11] E120 Crash when set to 38400 BAUD - AIS is NMEA 0183

An observation from my vessel that is configured much the same way, here in the pacific NW (Seattle/Vancouver area), I've observed that the E120 will sometimes loose contact with an AIS target despite it clearly being in range (visually) and being visible via an independent source like Marine Traffic, yet be redisplayed sometime later. My presumption is that the older plotter may get overwhelmed with too much AIS data along with other chores like chartplotting and radar overlay. Comment Chuck?

« Next Oldest | Next Newest »

Messages In This Thread

[CA11] E120 Crash when set to 38400 BAUD - AIS is NMEA 0183 - ckroeger - 06-18-19, 02:56 PM

RE: [CA11] E120 Crash when set to 38400 BAUD - AIS is NMEA 0183 - Chuck - Raymarine - Moderator - 06-20-19, 12:46 PM

RE: [CA11] E120 Crash when set to 38400 BAUD - AIS is NMEA 0183 - ckroeger - 06-25-19, 09:09 AM

RE: [CA11] E120 Crash when set to 38400 BAUD - AIS is NMEA 0183 - Chuck - Raymarine - Moderator - 06-25-19, 09:35 AM

RE: [CA11] E120 Crash when set to 38400 BAUD - AIS is NMEA 0183 - lotharjt - 07-01-19 09:07 AM

RE: [CA11] E120 Crash when set to 38400 BAUD - AIS is NMEA 0183 - Chuck - Raymarine - Moderator - 07-01-19, 11:08 AM

User(s) browsing this thread: 2 Guest(s)