cursor does not move with vessel symbol

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

cursor does not move with vessel symbol

06-03-16, 11:26 AM (This post was last modified: 06-06-16 09:43 AM by Chuck - Raymarine - Moderator.)

Post: #5

captc36 Offline

Junior Member

Posts: 4
Joined: May 2016
Reputation: 0

RE: cursor does not move with vessel symbol

followed this recommendation but had to change page set to do it. I was using a custom page set. had to change to chart/radar/sonar set to make change. now chart and radar are set in RM. However I established two split screens, chart/sonar and chart/radar. in both cases chart is in auto range and cursor will not follow ship. these charts it will not allow me to move from AR to RM. radar screen is in RM

« Next Oldest | Next Newest »

Messages In This Thread

cursor does not move with vessel symbol - captc36 - 05-27-16, 12:05 PM

RE: cursor does not move with vessel symbol - Chuck - Raymarine - Moderator - 05-27-16, 12:15 PM

RE: cursor does not move with vessel symbol - captc36 - 05-27-16, 12:46 PM

RE: cursor does not move with vessel symbol - Chuck - Raymarine - Moderator - 05-27-16, 12:55 PM

RE: cursor does not move with vessel symbol - captc36 - 06-03-16 11:26 AM

RE: cursor does not move with vessel symbol - Chuck - Raymarine - Moderator - 06-06-16, 03:36 PM

User(s) browsing this thread: 2 Guest(s)