[LW11] DSM30 or 300 wont take update from E90W

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[LW] [LW11] DSM30 or 300 wont take update from E90W

07-03-19, 01:21 PM (This post was last modified: 07-09-19 10:08 AM by Louise - Raymarine - Moderator.)

Post: #1

unixdood Offline

Member

Posts: 87
Joined: Mar 2016
Reputation: 0

[LW11] DSM30 or 300 wont take update from E90W

HI,
I have an E90W with a DSM30. Been trying to update the SW but keep getting the error (transfer failed) but I have no issues connecting and using the current DSM30. Just wanted to update the SW to see if I could get the TEMP to work with my B744V transducer.
I also have a DSM300 and when thats connected it all works fine also but the update wont transfer either. Same error. I am using a Raymarine switch for the ethernet backbone.
Is there any trick to get this update over to the DSM's? I have a CF card with the 4.20 SW and the E90W boots into the update SW app without any issues.

Thanks
Bill

« Next Oldest | Next Newest »

Messages In This Thread

[LW11] DSM30 or 300 wont take update from E90W - unixdood - 07-03-19 01:21 PM

RE: [LW11] DSM30 or 300 wont take update from E90W - Louise - Raymarine - Moderator - 07-09-19, 10:18 AM

RE: [LW11] DSM30 or 300 wont take update from E90W - unixdood - 07-10-19, 05:58 AM

RE: [LW11] DSM30 or 300 wont take update from E90W - Louise - Raymarine - Moderator - 07-10-19, 10:07 AM

RE: [LW11] DSM30 or 300 wont take update from E90W - unixdood - 07-11-19, 10:23 AM

RE: [LW11] DSM30 or 300 wont take update from E90W - Louise - Raymarine - Moderator - 07-12-19, 05:17 AM

RE: [LW11] DSM30 or 300 wont take update from E90W - Nbt22555 - 07-12-19, 10:33 AM

RE: [LW11] DSM30 or 300 wont take update from E90W - Nbt22555 - 07-12-19, 11:23 AM

RE: [LW11] DSM30 or 300 wont take update from E90W - Louise - Raymarine - Moderator - 07-31-19, 03:02 AM

User(s) browsing this thread: 4 Guest(s)