The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Autopilots v / [TG] Commission ST70 X10 Pilot

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] Commission ST70 X10 Pilot
07-07-19, 03:29 PM (This post was last modified: 07-15-19 04:58 AM by Tom - Raymarine - Moderator.)
Post: #1
johnhcarter Offline
Junior Member
**
 		Posts: 2
Joined: Jun 2019
Reputation: 0
Commission ST70 X10 Pilot
Having problem with pilot. Checked fluxgate compass wires and all wires test correct. Pilot works but compass is about 90 degrees off. Also Axiom does not recognize that a pilot is connected. Upgraded the Axiom software and assume the Axiom upgraded the ST70 and X10. Tried to run the commission routine on the ST70 but the display will not let me select options and will not let me do the drive the boat in a circle thing to commission the pilot. Please let me know next steps to test or repair. Sent X10 to Raymarine last summer and it came back no repair needed. However, problem still exists. Could it be the ST70 control head?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Commission ST70 X10 Pilot - johnhcarter - 07-07-19 03:29 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication