[CA11] New wind transducer (connected via itc5) stopped working

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[CA] [CA11] New wind transducer (connected via itc5) stopped working

07-15-19, 03:31 PM (This post was last modified: 07-16-19 10:41 AM by Chuck - Raymarine - Moderator.)

Post: #3

kray

Junior Member

Posts: 2
Joined: Jun 2019
Reputation: 0

RE: [CA11] New wind transducer (connected via itc5) stopped working

Dear Support,

since the wind transducer still sends corrupt data I decided to unmount the masthead Wind transducer.

It appeared that the masthead connector was pouring wet, the electrical contacts were heavily corroded.

Since I installed the wind transducer exactly as described in the manual and apparently the sealing completely failed after being exposed to the weather for only about 2-3 months.

Please advise on how to proceed.

« Next Oldest | Next Newest »

Messages In This Thread

[CA11] New wind transducer (connected via itc5) stopped working - kray - 06-10-19, 11:35 AM

RE: [CA11] New wind transducer (connected via itc5) stopped working - Chuck - Raymarine - Moderator - 06-11-19, 03:22 PM

RE: [CA11] New wind transducer (connected via itc5) stopped working - kray - 07-15-19 03:31 PM

RE: [CA11] New wind transducer (connected via itc5) stopped working - Chuck - Raymarine - Moderator - 07-16-19, 10:49 AM

User(s) browsing this thread: 1 Guest(s)