[CA] [CA11] JL Audio MM100S to Axiom

[Chuck - Raymarine - Moderator]

Welcome to the Raymarine Forum jpjudge,

A powered and properly terminated SeaTalkng / NMEA 2000 backbone must be installed onboard to permit the marine electronics to communicate with one another ... this is not to be confused with the engine system's backbone (ex. Yamaha Command Link, Mercury SmartCraft, etc.). Each marine electronic device featuring a NMEA 2000 communications interface, Raymarine or third party, must then be connected to a spur socket within this SeaTalkng / NMEA 2000 backbone. Accordingly, the SeaTalkng / NMEA 2000 backbone must feature a sufficient number of spur sockets to accommodate the devices which will be interfaced to it. Should the SeaTalkng / NMEA 2000 backbone have been constructed from Raymarine SeaTalkng Networking components, then any one of the following may be used to connect the JL Audio product to a spur socket within the SeaTalkng / NMEA 2000 backbone:
- A06045 / 15.7in (0.4m) SeaTalkng Spur to DeviceNet (F)
- A06075 / 39.4in (1.0m) SeaTalkng Spur to DeviceNet (F)
- A06082 DeviceNet (F) to SeaTalkng (M) Adapter and an appropriate length of SeaTalkng Spur Cable.

Finally, it is recommended that the system's Raymarine MFD's be updated with LightHouse 3 v3.10.x (released earlier today) or later software and that the marine entertainment system also be updated with the latest available software. Please additionally note that Raymarine products exclusively support SiriusXM program selection within systems featuring a compatible SiriusXM Marine Satellite Weather / Radio Receiver which in turn has been set up with a SiriusXM Satellite Radio subscription. Please click here to view a FAQ addressing this subject.