[TG] [TG11] E95 does not output AIS data on NMEA0183

[Tom - Raymarine - Moderator]

Hello GSwannell,

The e95 doesn't bridge incoming NMEA2000 data to NMEA0183. That's by design, and I think is probably because of the high likelihood of NMEA data loops, the limited utility to the majority of users of such a conversion, and the fact that that conversion would only work if the port speed were 38400 (AIS data can't be transmitted at the standard NMEA0183 rate of 4800.) In general, we tend to stick with a convention that only devices which produce a particular data type should transmit transmit that data, in order to avoid loops/duplication and make sure that that data is 'authoritative'.

The best way to do what you're after is to disconnect the AIS650 from NMEA2000 and connect to both the PC and e95 via NMEA0183 instead. You can split an NMEA0183 'talker' device's output to two 'listeners', just not the other way round (two talkers to one listener will corrupt each other's data.) Don't be tempted to try to connect to both NMEA2000 and NMEA0183 at the same time.

Having said 'best way' above, I will just say that NMEA0183 is awful, long obsolete, causes no end of problems and should be avoided wherever possible. Connecting two devices in one direction is ok, but anything more complex than this tends to start introducing problems.

Regards,
Tom