Raymarine forum / Raymarine Forums / AIS v / [LW] [LW11] Axiom 9 chart plotter compatibility with st60 and st6002

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[LW] [LW11] Axiom 9 chart plotter compatibility with st60 and st6002
07-23-19, 11:15 AM (This post was last modified: 07-23-19 01:43 PM by Chuck - Raymarine - Moderator.)
Post: #7
Papa Ralph Offline
Junior Member
**
 		Posts: 9
Joined: Jul 2016
Reputation: 0
RE: [LW11] Axiom 9 chart plotter compatibility with st60 and st6002
Louise, thanks for the quick response, but what I would like to know is HOW or what I have to do to get the waypoints and route to the S1 autopilot controller?

I'm new to the Axiom and don't see any menu to do this. is it done automatically? Do I have to enable some setting. I did set a waypoint on the plotter but didn't see anything on the Autopilot.

If this info gets to the Autopilot I would assume then I could have the pilot goto that waypoint, correct?

thanks again,

Ralph
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [LW11] Axiom 9 chart plotter compatibility with st60 and st6002 - Papa Ralph - 07-23-19 11:15 AM

Forum Jump:


User(s) browsing this thread: 2 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication