[CA] [CA11] I70s and fuel burn

[nharrison5]

I upgraded the software on my eS127. I am running FoxMarine MeFI’s On two Crusader 6.0 MPI engines. This was the same setup I was using with LH II. On the I70s I had a custom page setup in LH II I attempted to replicate in LH III.

The page has 6 “buckets”. I had speed, depth, the RPM’s for each engine and the fuel flow for each engine. With the new LH III I attempted the same things. I created the speed, depth, the RPM’s for each engine, and the fuel flow rate for each engine. Everything works except for the fuel flow. When I start the port engine, I get a certain fuel flow rate. When I start the starboard, the fuel flow rate roughly doubles.