[DG] [DG11] Reset st6001 autopilot

[Louise - Raymarine - Moderator]

Dear [email protected],

Thank you for your post.

You cannot reset the control head to cancel the alarm, the alarm is programmed to alert you of the low battery issue and cannot be switched off.

The first thing to look at is any corrosion or dirty connections on the network including the back of the ST6001 and connections on the course computer..etc , are all the cables looking healthy with no breaks, twists or bends?

Is there a healthy 12v supply going to the ST6001? measure this with a voltmeter. Is there a healthy 12v supply going to the autopilot? measure this with a voltmeter. Ensure you have over 12.5v being supplied.

Corroded connections and damaged cables can reduce the efficiency of the power supply causing this issue.

Many Thanks
Louise