[CA] [CA11] ST1000 and ITC-5

[Chuck - Raymarine - Moderator]

Welcome to the Raymarine Forum cmackg,

It is not possible to interface these ST1000 to the system in the manner which you have suggested. An SeaTalk to SeaTalkng Converter would need to be added to the system's powered and properly terminated SeaTalkng / NMEA 2000 backbone. The The SeaTalk to SeaTalkng Converter Cable Supplied with the SeaTalk to SeaTalkng Converter Kit will be interfaced to the SeaTalk socket of the SeaTalk to SeaTalkng Converter. The yellow lead of this cable will be connected to terminal 4 (yellow / SeaTalk) of the ST1000 bulkhead connector. The shield lead of this cable will be connected to terminal 2 (blue / 0V) of the ST1000 bulkhead connector. The red lead of this cable will not be used and should be insulated to prevent shorting.