The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Networking / System Integration v / [CA] [CA11] Powering backbone

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Powering backbone
08-13-19, 05:48 AM (This post was last modified: 08-21-19 10:24 AM by Chuck - Raymarine - Moderator.)
Post: #1
tonyiiiafl Offline
Member
***
 		Posts: 70
Joined: Mar 2016
Reputation: 0
[CA11] Powering backbone
I have a backbone right now for the Raystar 130 that feeds both MFD’s. It is powered by the red cable into the white connector. I am adding another backbone 5 slot to it. I was going to connect it to the original with a blue backbone cable to integrate the Evolution Auto pilot. Is this one red cable enough to power the entire network, or do I need to run anther red power cable to the new backbone?

Also, I need to connect the heading sensor to the backbone. Can I use a white cable, connect it to he tee what has the white and terminate one end with the termination plug and run the back bone cable to the blue slot at the backbone 5 plug piece?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] Powering backbone - tonyiiiafl - 08-13-19 05:48 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication