[TG11] Axiom units chane from ft/miles to m/km

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[TG] [TG11] Axiom units chane from ft/miles to m/km

08-19-19, 04:48 PM (This post was last modified: 09-09-19 01:26 PM by Chuck - Raymarine - Moderator.)

Post: #1

[email protected] Offline

Member

Posts: 75
Joined: Jun 2016
Reputation: 0

[TG11] Axiom units chane from ft/miles to m/km

Hi have Axiom 12 and have units set up as ft,nautical miles ,temp F
have noticed on say 30 % of my trips that the units change to metric on there own . I then go back to settings and change them back.

Is there any reason for this happening or is their something else I can do to correct this so it does not happen. when it happens I am not doing anything but glance down and it is showing distance to way point in metric.

Note I have the Bermuda software installed about 3 weeks ago this has happened since June and just this past weekend

« Next Oldest | Next Newest »

Messages In This Thread

[TG11] Axiom units chane from ft/miles to m/km - [email protected] - 08-19-19 04:48 PM

RE: [TG11] Axiom units chane from ft/miles to m/km - Tom - Raymarine - Moderator - 08-26-19, 01:10 AM

RE: [TG11] Axiom units chane from ft/miles to m/km - [email protected] - 08-26-19, 05:09 PM

RE: [TG11] Axiom units chane from ft/miles to m/km - jorbro - 09-01-19, 05:00 AM

RE: [TG11] Axiom units chane from ft/miles to m/km - karlista - 08-26-19, 11:00 PM

RE: [TG11] Axiom units chane from ft/miles to m/km - Tom - Raymarine - Moderator - 08-27-19, 01:57 AM

RE: [TG11] Axiom units chane from ft/miles to m/km - Tom - Raymarine - Moderator - 08-27-19, 02:01 AM

RE: [TG11] Axiom units chane from ft/miles to m/km - Tom - Raymarine - Moderator - 09-10-19, 10:52 PM

User(s) browsing this thread: 2 Guest(s)