[TG11] Adding Element S to STNG network with Axiom 9

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[TG] [TG11] Adding Element S to STNG network with Axiom 9

08-20-19, 02:31 AM (This post was last modified: 11-14-19 07:45 PM by Chuck - Raymarine - Moderator.)

Post: #2

Tom - Raymarine - Moderator Offline

Administrator

Posts: 1,067
Joined: Nov 2017
Reputation: 7

RE: [TG11] Adding Element S to STNG network with Axiom 9

Hello Indulgence,

At the current time, you cannot put these displays into the same NMEA2000 network. The Element will prompt a warning saying that an incompatible MFD has been detected and will not be usable until this has been disconnected and the Element power-cycled afterwards.

I don't have information on the exact reason for this, but I would guess that it's to do with the different ways the displays' different software synchronise things like data-source selection.

Regards,
Tom

Raymarine since 1999.
Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras
Location: Sydney, Australia.

Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests.

« Next Oldest | Next Newest »

Messages In This Thread

[TG11] Adding Element S to STNG network with Axiom 9 - Indulgence - 08-09-19, 06:31 AM

RE: [TG11] Adding Element S to STNG network with Axiom 9 - Tom - Raymarine - Moderator - 08-20-19 02:31 AM

RE: [TG11] Adding Element S to STNG network with Axiom 9 - Pete7 - 11-14-19, 05:03 PM

RE: [TG11] Adding Element S to STNG network with Axiom 9 - Tom - Raymarine - Moderator - 11-19-19, 11:26 PM

RE: [TG11] Adding Element S to STNG network with Axiom 9 - Pete7 - 12-05-19, 08:43 AM

User(s) browsing this thread: 2 Guest(s)