The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Autopilots v / Smart Controller and Base Station/Seatalk ng

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Smart Controller and Base Station/Seatalk ng
06-08-16, 05:02 PM
Post: #1
Seebaer Offline
Junior Member
**
 		Posts: 1
Joined: Jun 2016
Reputation: 0
Smart Controller and Base Station/Seatalk ng
I just did a complete refit with new Seatalk ng instruments, Evolution AP, sG MFD etc. The old intrumentation died due to a lightning strike. My client would like to keep his Smart Controller and Base Station to control the AP.
I connected the Base Station to a Seatalk/Seatalk ng converter, but apparently there seems to be a problem. The Smart Controller shows the bars for communication with the Base Station alright, but does not get any data from the bus plus it shows "no pilot".
SW version on the converter is V2.01, so should be ok. The LED on the controller indicates that there is no compatible Seatalk device detected.
Also, the base station is not displayed in the MFD list of connected devices.
Is it possible that the base station has been damaged in the lightning and now doesn't communicate via Seatalk, but still establishes communication with the controller?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Smart Controller and Base Station/Seatalk ng - Seebaer - 06-08-16 05:02 PM

Forum Jump:


User(s) browsing this thread: 5 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication