Raymarine forum / Raymarine Forums / Networking / System Integration v / [CA] [CA11] Powering backbone

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Powering backbone
08-21-19, 10:10 AM (This post was last modified: 08-21-19 10:24 AM by Chuck - Raymarine - Moderator.)
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: [CA11] Powering backbone
Welcome back to the Raymarine Forum Tony,

Q1. Is this one red cable enough to power the entire network,
A1. Yes

Q2. Do I need to run anther red power cable to the new backbone?
A2. No.

Q3. Also, I need to connect the heading sensor to the backbone. Can I use a white cable, connect it to he tee what has the white and terminate one end with the termination plug and run the back bone cable to the blue slot at the backbone 5 plug piece?
A3. If the with cable which you are referring to is a SeaTalkng Spur Cable (black w/white stripe), then the answer is yes.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] Powering backbone - tonyiiiafl - 08-13-19, 05:48 AM
RE: [CA11] Powering backbone - Chuck - Raymarine - Moderator - 08-21-19 10:10 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication