[LW] [LW11] i70S w. elbow spur connector, space requirement?

[SYBY]

Hi Louise,

thanks for your reply.
My wording was probably a bit unclear, I will try to elaborate and rephrase my question:

I intend to install the instrument on a wooden bulkhead. However, I am not willing to cut a [censored] in the bulkhead to accommodate the recessed part of the instrument or the connector/cable. Instead I will make a wooden 'frame' or 'box' to serve as an instrument pod, attached to the bulkhead. The cable will come in through a [censored] in the bottom or sidewall of the frame.
What I need to find out is the minimum thickness of this frame.
The dimensional drawing for the i70S shows that there is space requirement of 29.8mm for the recessed part, including the 'locking ring'. To this measurement must be added the space requirement for the elbow connector of the A06042, when mated to the instrument – which is really the piece of information I am missing.
I understand and accept that I will need to unmount the instrument to disconnect the cable.
Thanks for your patience.
SYBY