The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / General Discussions v / [CA] [CA11] C-80 COG after Factory reset

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] C-80 COG after Factory reset
08-23-19, 10:47 AM (This post was last modified: 08-26-19 03:39 PM by Chuck - Raymarine - Moderator.)
Post: #1
drbridge Offline
Junior Member
**
 		Posts: 7
Joined: Jun 2017
Reputation: 0
[CA11] C-80 COG after Factory reset
I accidentally did a factory reset on m Classic C-80. I have been able to get every thing set back up the way I had it previously to the reset except that it is not displaying a Course Over Ground now. If I engage the auto pilot and "Go Too" the curser it will track correctly and display the course over ground in the display bar, but will not show the green COG indicating line on the display. When the auto pilot is disengaged it does not show any COG info. Everything worked great until I hit the factory reset and I have gone through everything in the menu over and over and I can't figure out what setting is not right. Can you Help?
Thanks, Doug
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] C-80 COG after Factory reset - drbridge - 08-23-19 10:47 AM

Forum Jump:


User(s) browsing this thread: 2 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication