[CA] [CA11] AIS650 will not exit silent mode

[Chuck - Raymarine - Moderator]

Welcome to the Raymarine Forum

General comments: The attached screen snapshots of the ProAIS2 software have not been populated because a COM port corresponding the AIS Class B Transceiver has not been selected from the pull down list and the Connect button has not been exercised.

The blue status LED indicates that the AIS transceiver is in silent mode. Should a MMSI have not been entered, then this Status LED would be typically be red. The unit's Status LED will be amber after the MMSI is entered. The Status LED will change to green after the unit has acquired a GPS position FIX. As indicated above, the blue Status LED is indicating that the unit has been commanded into Silent Mode.

Q1. Does MMSI configuration appear to be the cause of our problem? or could it be something else?
A1. I do not believe so. It is recommended that communications be established between the ProAIS2 software and the AIS650 to verify that it has been programmed with a MMSI and that it has been updated with the latest available Raymarine product software update. If not operating with the latest available software, then it should be updated accordingly.

Q2. Does this HAVE to be done by a certified Raymarine tech? If so, what is the best process to activate warranty? We are sailing in Long Island Sound, away from home port.
A2. FCC regulations require that MMSIs be entered by FCC licensed technicians, professional marine electronics installers, or marine electronics dealers.

Q3. If configuration can be done by users, then is incompatibility with Mac OSX the reason why we could not do it ourselves?
A3. See the response to Q2.

Q4. Also, should AIS be ON or OFF when configuration is done?
A4. Whenever connecting the AIS650 to a PC, the AIS650's Power/NMEA 0183 cable should be disconnected from the AIS650.