[DG11] New install CPT-110 not found

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[DG] [DG11] New install CPT-110 not found

08-24-19, 06:38 AM (This post was last modified: 08-26-19 08:52 AM by Chuck - Raymarine - Moderator.)

Post: #3

developers Offline

Junior Member

Posts: 12
Joined: Dec 2017
Reputation: 0

RE: [DG11] New install CPT-110 not found

I will be on the boat again in a few days. I will respond fully then. The extension is the Raymarine part. In any event I get the same situation with and without the extension cable so I have eliminated that making a difference.

So far as the transducer is concerned I only powered the MFD when the transducer is dangled just into the sea. Is it safe to power up whilst out of the water to listen for the ticking sound?

Thanks for the assistance. Jem

Oceanis 40 es98 CPT110, AIS 650 dedicated aerial and gps, two i70s, transponder - digital depth speed temperature -ST60 masthead wind via analogue to stng pod, P70s control head, Seatalkng to Seatalk interface to S3g autopilot to type 2 linear drive & Ray240e VHF both aquiring gps via Seatalk interface.

« Next Oldest | Next Newest »

Messages In This Thread

[DG11] New install CPT-110 not found - developers - 08-13-19, 02:27 AM

RE: [DG11] New install CPT-110 not found - Louise - Raymarine - Moderator - 08-23-19, 03:42 AM

RE: [DG11] New install CPT-110 not found - developers - 08-24-19 06:38 AM

RE: [DG11] New install CPT-110 not found - Derek - Raymarine - Moderator - 08-27-19, 06:30 AM

RE: [DG11] New install CPT-110 not found - developers - 08-26-19, 10:35 AM

RE: [DG11] New install CPT-110 not found - Derek - Raymarine - Moderator - 08-27-19, 06:31 AM

RE: [DG11] New install CPT-110 not found - developers - 08-28-19, 01:45 AM

User(s) browsing this thread: 1 Guest(s)