[CA11] C-80 COG after Factory reset

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[CA] [CA11] C-80 COG after Factory reset

08-26-19, 03:42 PM

Post: #2

Chuck - Raymarine - Moderator Offline

Administrator

Posts: 14,319
Joined: Oct 2014
Reputation: 43

RE: [CA11] C-80 COG after Factory reset

Welcome to the Raymarine Forum Doug,

The COG vector may be configured ON/OFF via the command sequence DATA->CHART VECTORS->COG VECTOR. Vector length may be configured via the command sequence MENU->CHART SET-UP->VECTOR LENGTH.

« Next Oldest | Next Newest »

Messages In This Thread

[CA11] C-80 COG after Factory reset - drbridge - 08-23-19, 10:47 AM

RE: [CA11] C-80 COG after Factory reset - Chuck - Raymarine - Moderator - 08-26-19 03:42 PM

View a Printable Version
Send this Thread to a Friend
Subscribe to this thread

User(s) browsing this thread: 2 Guest(s)