[DG] [DG11] Wind speed showing boat speed

[Max Bonieux]

Hi,
I have a ST60+, software version 7.03, boat speed and depth are working fine but wind speed and wind direction are not working. Wind speed is showing 0.00 at anchor (with wind) and shows exactly the same figure as boat speed when sailing or motoring (under true wind setting). Wind direction doesn't reflect reality, mainly showing straight in the 60° range even when the wind is from behind.
Both wind direction and speed sometimes work, but very rarely, when it does it's for a few seconds and then wind speed will drop slowly to 0 again.
I purchased a new wind transducer after it's been tested by a raymarine agent who said it was faulty. Turns out that the new wind transducer didn't solve the problem.
Tested voltage behind the display: red 7.94 / green 5.0-5.5 / blue 2.2-3.5 / yellow 2.5-3.0 all in the range apart the red which just below 8.0. Is that ok? I have tested on the conection at the base of the mast and have the same figures. But haven't tested the voltage at the top of the mast.
I mounted the display on a friends boat and it works fine. I have redone all connection behind display and base of mast. I checked the dealer calibration settings, all good, wind factor is set to 0.7.

Thanks in advance for your help.
Max.