Raymarine forum / Raymarine Forums / Networking / System Integration v / [CA] [CA11] Seatalk ng connections

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Seatalk ng connections
09-16-19, 10:49 AM (This post was last modified: 09-16-19 10:50 AM by Chuck - Raymarine - Moderator.)
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: [CA11] Seatalk ng connections
Welcome to the Raymarine Forum wing15601,

When properly constructed, a backbone will be left with two unoccupied backbone (blue) sockets ... one at each end of the backbone. A SeaTalkng Termination Plug (blue) will be inserted into each of these two sockets. It is recommended that an A06032 SeaTalkng Blanking Plug be installed within any unoccupied spur (white) sockets within a SeaTalkng networking component or device within the network. The blanking plug will seal the spur socket to prevent potential damage from the marine environment.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] Seatalk ng connections - Chuck - Raymarine - Moderator - 09-16-19 10:49 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication