[CA] [CA11] Deepwater area in white vs blue.

[jgonnerman]

I have an e125 using a Navionics+ card. I recently renewed and updated the card. 9/10/2019
Since that action I can no longer view deep water (set as a value for a given contour line depth) in white. It only shows in blue.

The only change I made was the card update, no changes to set up in the MFD. I did go into the set ups after I observed that the deep water no longer showed in white.

I am along the SoCal coast so most of the chart should show in white especially when showing larger area. I used the 12 foot contour line as my boat only draws 3 feet.

My MFD software is version is v19.03-00036. I don't see a later software version.

Any suggestions. Is this a Navionics issue?

Thank you