[DG11] S100 installation problem

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[DG] [DG11] S100 installation problem

09-20-19, 08:24 AM

Post: #4

Derek - Raymarine - Moderator Offline

Administrator

Posts: 1,416
Joined: Nov 2017
Reputation: 9

RE: [DG11] S100 installation problem

Hi Rene,

The base station for the the S100 must be connected through a SeaTalk to STng converter, (E22158) correctly connected into the current backbone and the converter cable from the yellow socket of the E22158 SeaTalk to STng converter block connected to the base station.

Just using the converter cable on its own will not work and cause the symptoms shown on your display.

Regards
Derek

« Next Oldest | Next Newest »

Messages In This Thread

[DG11] S100 installation problem - Rene.Postulart - 09-16-19, 02:45 PM

RE: [DG11] S100 installation problem - Louise - Raymarine - Moderator - 09-17-19, 08:51 AM

RE: [DG11] S100 installation problem - Rene.Postulart - 09-18-19, 03:01 PM

RE: [DG11] S100 installation problem - Derek - Raymarine - Moderator - 09-20-19 08:24 AM

RE: [DG11] S100 installation problem - Rene.Postulart - 09-21-19, 03:00 PM

RE: [DG11] S100 installation problem - Derek - Raymarine - Moderator - 09-23-19, 07:50 AM

RE: [DG11] S100 installation problem - Rene.Postulart - 09-23-19, 01:01 PM

RE: [DG11] S100 installation problem - Derek - Raymarine - Moderator - 09-24-19, 03:02 AM

RE: [DG11] S100 installation problem - Rene.Postulart - 09-29-19, 10:33 AM

RE: [DG11] S100 installation problem - Louise - Raymarine - Moderator - 09-30-19, 05:27 AM

User(s) browsing this thread: 1 Guest(s)