The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Multifunction Displays v / [CA] [CA11] Axiom pro power cable

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Axiom pro power cable
09-24-19, 12:48 PM (This post was last modified: 09-24-19 02:07 PM by Chuck - Raymarine - Moderator.)
Post: #1
Mark maulden Offline
Junior Member
**
 		Posts: 24
Joined: Apr 2016
Reputation: 0
[CA11] Axiom pro power cable
My system consists of E7D, HD radar, spx-5 pilot, AIS 650, splitter, P-70..I am replacing the plotter with an axiom pro. The power cable for both look to be nearly identical in build, connector, etc. can i use the E7D power cable for the axiom which is already routed through the binnacle etc etc? If not, why? I understand the part numbers are different. Functionally, can it be done? I’m only using power/ground, and four NMEA wires. Unless the pin assignments in the connector have changed, I see no reason not to.
Also, i received no install manual for the axiom. How am I supposed to know the wire assignments by color? Can I have a manual sent to me?
Tnx
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] Axiom pro power cable - Mark maulden - 09-24-19 12:48 PM

Forum Jump:


User(s) browsing this thread: 2 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication