Raymarine forum / Raymarine Forums / Instruments v / [CA] [CA11] I50 and I60 compatible with my present hardware?

Post Reply 
 
Thread Rating:
  • 1 Vote(s) - 3 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] I50 and I60 compatible with my present hardware?
09-25-19, 01:43 PM
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: [CA11] I50 and I60 compatible with my present hardware?
Welcome to the Raymarine Forum Udo,

Q1. The I50 and I60 are fully compatible with my existing Raymarine hardware and the SeaTalkng network?
A1. Correct. It is recommended that these instruments be interfaced as individual spurs to the NMEA 2000 backbone to which the MFD and autopilot components have been interfaced. These instruments may also be daisy chained to create a spur linking up to three devices. The maximum total length of spur cable used within the daisy chain should not exceed 6m.

Q2. I know there is a tacking feature on the P70 autopilot, but this only works with information from a windsensor / wind data, so I hope this will work in conjuction with the I60?
A2. Interfacing an i60 Wind instrument to the system will indeed support use of the autopilot's wind dependent features.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] I50 and I60 compatible with my present hardware? - Chuck - Raymarine - Moderator - 09-25-19 01:43 PM

Forum Jump:


User(s) browsing this thread: 4 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication