[DG11] ST7001 Autopilot Not Displaying HDG or COG

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[DG] [DG11] ST7001 Autopilot Not Displaying HDG or COG

09-30-19, 08:39 AM (This post was last modified: 09-30-19 08:41 AM by Derek - Raymarine - Moderator.)

Post: #6

Derek - Raymarine - Moderator Offline

Administrator

Posts: 1,416
Joined: Nov 2017
Reputation: 9

RE: [DG11] ST7001 Autopilot Not Displaying HDG or COG

Hi Mr Yorke,

If there have been no cases of guests onboard having an 'experiment' with the control unit, then the next most likely cause is a voltage spike or brownout.

You should check the battery status, the charging system, other sources of electrical noise onboard which may have triggered this reset, also check out power cables for any loose connections or dirty switch contacts. Also check out this link here for further information.

Kind regards
Derek

« Next Oldest | Next Newest »

Messages In This Thread

[DG11] ST7001 Autopilot Not Displaying HDG or COG - mikeyor - 09-25-19, 12:04 PM

RE: [DG11] ST7001 Autopilot Not Displaying HDG or COG - Derek - Raymarine - Moderator - 09-26-19, 03:45 AM

RE: [DG11] ST7001 Autopilot Not Displaying HDG or COG - mikeyor - 09-26-19, 03:02 PM

RE: [DG11] ST7001 Autopilot Not Displaying HDG or COG - Derek - Raymarine - Moderator - 09-27-19, 06:40 AM

RE: [DG11] ST7001 Autopilot Not Displaying HDG or COG - mikeyor - 09-27-19, 05:43 PM

RE: [DG11] ST7001 Autopilot Not Displaying HDG or COG - Derek - Raymarine - Moderator - 09-30-19 08:39 AM

User(s) browsing this thread: 1 Guest(s)