[CA] [CA11] Help designing new system for large center console

[Chuck - Raymarine - Moderator]

Mig888,

Q1. I was actually a member of this forum years ago, but don't know what happened as my membership seemed to be dropped.
A1. The membership was likely within Raymarine's prior forum. Unfortunately, memberships were not migrated to the current forum.

Q2. I assume there is no way to connect more than one camera to film at the same time so that I can increase the field of vision to 186 degrees.
A2. While it is possible to display create a two pane page in which each pane has been configured to run the Video app and then manually point the cameras to provide an apparent 180 degree view, only video from one of the CAMs will be recorded within the video file created (i.e. LH3 software presently does not support simultaneous recording of video from two different sources.

Q3. Can you suggest how I should position these Should I have both of the back with one filming aft and starboard and the other filming aft and port or should I simply center one in the back and one in the front?
A3. That's a subjective question You may want to consider trying a single aft facing camera and if found to not provide a sufficient field of view, then the second camera may be added. If electing to go with two after facing cameras, then they should be installed adjacent to one another on either side of centerline. Should you want to try it before installing the second aft facing camera, then you may want to ensure that the vessel is wired to accommodate the second aft facing camera.